Going back to the computer, while the Kapton tape is on the third pin, connect the power cable which will slip right over the tape, and then the data cable. The tape is too long for the pin, so snip off the excess with some scissors. I highly recommend that you use an ESD wrist strap while you're doing this, as you are touching the contacts of the drive. Next, on the hard drive, locate the third pin, and gently apply the tape. The goal here is to cut a thin strip of tape - enough to cover that third pin - so take a razor and gently slice off a strip of tape. Then take a piece of cardboard and place it underneath. Take a piece of backing paper from a sheet of labels and place the tape onto it. It's a special type of non-conductive tape that's stable at both low and high temperatures, and is yellowish in color. The first solution involves a piece of Kapton tape to cover that third pin.
0 Comments
Leave a Reply. |